#WAKE ON MAC FOR WINDOWS HOW TO#

Note, you do not have to enter these numbers every time the little program is smart enough to remember them. Press the button 'Wake Me Up,' and your Mac should wake up accordingly. Put the IP Address in the 'Internet Address' box, the Subnet Mask in the 'Subnet Mask' box, and the Ethernet ID in the 'Mac Address' box (remove the colons). Put your Mac to sleep, and take your noted numbers to your PC box. In System Preferences, go to 'Energy Saver,' click on the 'Options' tab, and make sure 'Wake for Ethernet network administrator access' is selected. Click the Ethernet tab and then write down the 'Ethernet ID.' Your numbers should look similar to the following (hypothetical of course) example: Under the TCP/IP tab, write down your IP Address and Subnet Mask.

Select your built-in ethernet and click 'Configure.'. Please do your homework in regard to allowing your Mac or PC to be turned on remotely by all the naughty children out there.ДЇirst, get the necessary information from your Mac by first going to System Preferences, then Network.

Also note that some computers may or may not be able to do this (your mileage may vary). Please note that this was only tested on the latest versions of Windows XP and Panther on a local Ethernet network.

#WAKE ON MAC FOR WINDOWS HOW TO#

It took me hours of research to figure this out, so I thought I would share the wealth regarding how to wake from standby/sleep a Mac from a PC, or a PC from a Mac.

Wake on mac for windows